
Waterra Inertial Pumps: High Flow System and Accessories
|
Maximum flow rate (under ideal conditions) is between 10 and 15 litres per minute.
The system can also be used for cleaning and development of 50mm diameter monitoring boreholes using a Waterra Surge Block.
Normal Operating Parameters
| Borehole Diameters | 30 to 200mm |
| Depth of Operation |
Manual: up to 10m Powered*: up to 40m |
| Pumping Rate | Up to 15 l/min |
For further technical information and applications see:
- Applications Sheet (6 sampling systems, 3 pumping methods)
- Set up and User Guide (field manual, hints & tips)
- Technical Data (physical dimensions & pumping performance)
For more details:
or
High Flow Stainless Steel Low Profile Foot Valves and Accessories - Internal Fit
|
The "VS" range of low profile, round-headed, internal-fitting inertial pump valves provide minimum hydraulic resistence and maximum pumping efficiency. Designed with cutting screw threads, they are simply and quickly attached to tubing using a Hex key (supplied separately). |
|
|
|
|
||||||
|
||||||||
High Flow Delrin Foot Valves and Accessories - External Fit
|
Our original Waterra foot valves are moulded from Delrin plastic to provide a high quality plastic valve for general use. Unlike other inferior plastics, Delrin has low absorptive / desorptive properties and is ideal for routine environmental sampling programmes. |
|
|
|
|
||||||
|
||||||||
High Flow HDPE Tubing and Accessories
|
High Flow HDPE tubing for downhole use. Available in two coil sizes which can then be cut to lengths. Ideal for dedicated applications. Use with either external (D-32) or internal fitting (VS5) foot valves. |
|
|
|
|
|||||||||
|
|||||||||||
High Flow PVC Discharge Tubing
|
Disposable PVC tubing for controlling surface discharge of purge water. Push fits over the end of Waterra High Flow tubing. |
|
|
|
|
|||
|
|||||
Tubing Cutter with Teflon Blade
|
The Waterra tube cutter (WTC-1) is faster and safer to use than a hacksaw or utility knife and provides straight, clean cuts to tubing with no burring. |
|
|
|
|
|||
|
|||||
High Flow Delrin Surge Blocks (48mm OD)
|
Delrin Surge Blocks are used in 50mm diameter boreholes to enhance borehole development and remove sediment. The combination of mechanical surging and high volume pumping can remove water containing silt and fine sand without clogging. Add water to the borehole if necessary to loosen silt.
The SBHF Surge Block fits over the High Flow tubing and is held in place with a stainless steel grub screw directly above the Waterra foot valve. |
|
|
|
|
||||||
|
||||||||